JHD1130WP
6
PREONLY (On / Off): Turn preset-only tuning On/ Off.
BAT ALRM (Off / On): When ON, the radio will alert when the voltage of vehicle battery is
below 10.8 VDC.
BAT OFF (Off / On): When ON, the radio will automatically turn off when the voltage of
vehicle battery is below 10.8 VDC.
RESET ALL <ENTER>: Press the
INFO/ENTER
button to return the EEPROM to factory
default set up values.
Equalizer
Press the
EQ/LOUD
button (7) to choose one of the following pre-defined bass and treble
curves: USER > FLAT > ROCK > CLAS(SICAL) > POP.
Loudness
Press and hold
the
EQ/LOUD
button (7) to toggle loudness on/ off. When listening to music at
low volumes, this feature will boost the bass and treble ranges to compensate for the
characteristics of human hearing.
Auxiliary Input
To access an auxiliary device:
1.
Connect the portable audio player to the AUX IN
Connector
on the rear.
2.
Press the
MODE
button (3
) to select “Auxiliary” mode.
3.
Press
MODE
again to cancel “Auxiliary” mode and go to the next mode.
Liquid Crystal Display (LCD)
The current frequency and activated functions are shown on the LCD panel (22).
NOTE: LCD panels may take longer to respond when subjected to cold temperatures for
an extended period of time. In addition, the visibility of the characters on the LCD may
decrease slightly. The LCD display will return to normal when the temperature increases
to a normal range.
Setting the Clock
To set the clock to display the current time, turn the vehicle ignition on and turn the radio on.
Press
PTY/MENU
button (18) to enter the system menu and adjust the clock by selecting the
“CLK” menu item.
Press the
INFO/ENTER
button (19) to view the clock set screen.
Press the
TUNE/SEEK
◄◄
or
►►
buttons (20, 21) to adjust the selected digit.
Press the
INFO/ENTER
button to move to the next digit. The time will become set immediately
and normal operation will resume.
Display Modes
Press the
T/F
button (16) to switch between LCD clock display and source display..
