background image

Clock Operation

- Power off the unit.

- Press “CLK SET” button to access clock operation.

- Setting mode is active while the colon stops flashing.

Fold-out Stand

- The Main Battery Compartment at the rear also functions as a stand for the unit.

- Fully fold it out until the 2 spring-loaded buttons on either sides pop out and lock the stand in 

 place securely.
- To return the stand to its home cavity, press and hold the 2 buttons at the same time while folding 
 it up.

- Press “HOUR” button to adjust hour.

- Press “MIN.” button to adjust minute.

- Press “         ” button on unit to select 12/24 hour mode.

- Press “CLK SET” button to confirm setting and return to clock mode.

Alarm Time Setting Operation

- Power off the unit.

- Press “AL. SET” button to access alarm mode.

- The “ALARM” icon will flash in the display.

- Press “HOUR” button to adjust the hour.

- Press “MIN.” button to adjust the minute.

- Press “        ” button on unit to select Wake Mode: Buzzer / Radio / iPod.

- Press “AL. SET” button again to confirm the setting and return to clock mode.

- The “ALARM” icon and Buzzer/Radio/iPod icon will show on the display.

Note:

- If radio is selected, alarm turns on to the last station you were listening to.
- If wake to iPod is selected, alarm turns on and plays the last track you were listening to.
- If wake to iPod is selected without iPod player docked, it will switch to “Wake to Buzzer” automatically.
- If wake to iPod is selected, iPod must be properly docked and in off mode.
- Make sure your iPod has enough songs to play for 60 minutes, otherwise, please set the iPod to repeat mode.
- If the unit is in Power ON mode, the alarm is default as Wake to Buzzer.
- The Buzzer alarm volume level is fixed by factory setting.
- The iPod and Radio alarm sound level is same as last volume setting.

Alarm ON/OFF

- Press and hold the “SNOOZE/LIGHT” button, the alarm will toggle ON and OFF. 

- Press the Power button to stop the sounding alarm immediately.

SNOOZE / BACKLIGHT Operation

- When wake to buzzer/radio/iPod is sounding, press “SNOOZE/LIGHT” button to stop the alarm 

one time, the Buzzer/Radio/iPod icon will flash on display.  After 10 minutes, alarm will sound again. 

- The alarm will sound again the next day at the same time when alarm mode is set.

- During normal operation, press the “SNOOZE/LIGHT” button to turn the backlight ON and OFF.

Sleep Timer Operation

- Power on the unit

- While listening to iPod / Aux / Radio, press “SLEEP” button to enter “SLEEP” mode.

- Adjust the sleep timer by Timer OFF / 15 / 30 / 60 / 90 / 120 minutes.

- The “SLEEP” icon will show on the display.

- When sleep mode is active, press “SLEEP” button once to show the actual time.  Then press 

“SLEEP” button again for setting the sleep timer. 

- To terminate the Sleep Mode, press “SLEEP” until “OFF” is shown.

SETUP AND OPERATIONS

6

Summary of Contents for JiMS-120












Reviews: