Jensen JiMS-190, Owner'S Manual

8

If the docking port will not be used for an extended period of time, it is recommended to cover the docking 
port by using the “Dock Cover” insert (included).
1.Use the iPod adaptor included in your iPod and insert it into the docking area. Your iPod can now be 
    inserted into the docking port by placing the connector on the bottom of the iPod onto the connector in 
    the docking bay.
   

Note: 

Please be careful when seating the iPod into the docking to avoid damaging 

             the 30-pin connector on iPod or docking system.

2.Press the POWER On/Off button to switch on the docking system.

®

3.Press the FUNCTION button repeatedly until the indicator “iPod” shows on the display. The iPod  will 
   start playing and charging automatically.

®

4.Select your desired EQ and play mode in your iPod .
5.Press the VOL +/- button on the docking system to adjust your desired volume level

®

NOTE:The volume level cannot be adjusted by the volume control of your iPod  after being docked.

®

6.The iPod  is charging even during playback.
   

NOTE: The iPod will only charge in iPod, AUX, or power "OFF" modes.

®

7.To remove the iPod  from the unit, press and hold the PLAY/PAUSE button for three seconds to switch 
   off the device and then gently remove it from the docking connector.

®

You may control the playback of your iPod  by:

®

- Press the PLAY/PAUSE       button to pause or resume the iPod  playback;
- Press the iPod Skip/Search Forward      or Backward      button to skip to the next or previous song;
- Press and hold the iPod Skip/Search Forward     or Backward     button for fast-forwarding or 
  fast-rewinding during playback.

®

iPod  DOCKING