automatic tuning.
If the automatic tuning does not stop on the exact frequency of the station, for
example, it stops on 100.9 MHz instead of 100.8 MHz, use the manual tuning
method to "fine tune" to the exact frequency of the desired station.
If a station is broadcasting in Stereo, the unit will automatically receive the
stereo broadcast.
Hints
for the Best Reception
To obtain the best FM/FM Stereo reception, unwrap and fully extend the FM
Antenna and adjust the position of the wire for best station reception.
Setting the Radio Station Presets
The unit allows you to store up to
10
FM stations for easy recall at any time.
1.) In the FM mode, tune to the radio station you want to store in memory using
the
or
buttons.
2.) Press and hold the
RIGHT
side of the
CLOCK/MEMORY
button. The preset
channel number "P01" will be flashing on display.
3.) To change the preset channel number location, press the
or
buttons
to step through the preset locations (P01 – P10)
.
4.) To confirm the preset location, press the
RIGHT
side of the
CLOCK/MEMORY
button.
5.) To store up to 10 FM station presets, repeat steps 1 to 4 above.
Note
:
1. There is a 5 seconds delay when programming, after 5 seconds, the unit will
automatically switch back to normal tuner mode.
2. You can overwrite a present station by overwriting and storing the new
frequency in its place.
Recall Preset Radio Stations
1.) Set the unit to RADIO mode.
2.) Tap the
RIGHT
side of the
CLOCK/MEMORY
button and the preset channel
appears on the display. Press the
or
button
to recall preset stations.
Radio Broadcast System Selection
This unit comes preset to receive radio broadcasts in the USA, but the radio
receiver will also work in four other countries. The radio can be setup to also
receive broadcasts in Japan, Europe, Australia and Korea. Follow the directions
below to change the country.
1. Set the unit to Power Off mode.
10
