10.
Volume Down
Button
11.
Volume Up
Button
+
INSTALLATION
BACKUP BATTERY FOR CLOCK
This unit requires a 3V ”CR2032” battery(included) for the clock ,radio preset and
alarm memory back up. To active the clock backup function, remove the
insulation tab inserted in the battery compartment.
To change the battery proceed as follows
1. Open the battery door located on the bottom of the cabinet.
2. Remove the original battery from the holder and insert a new battery into the
holder the same way, observing the positive (+) and (-) direction.
WARNING:
DANGER OF EXPLOSION IF BATTERY IS INCORRECTLY
REPLACED. REPLACE ONLY WITH THE SAME OR EQUIVALENT TYPE.
Note:
Use a well-known brand of battery for longer life and best performance.
BATTERY CARE
i.
If the unit is not used for an extended period of time, remove the battery. An old
or leaking battery can cause damage to the unit and may void the warranty.
ii.
Do not dispose batteries in fire. Batteries may leak or explode.
iii. Do
not
try
to recharge batteries that are not intended to be recharged; they can
overheat, rupture and leak (Follow battery manufacturer’s directions).
iv. Only an adult should replace the battery.
CONNECTING THE AC POWER
An AC-DC Adaptor with 7.5V DC 2500mA output (included) is required for
operating the main unit. Connect the AC-DC Adaptor to the unit and AC outlet:
1.) Firmly and securely insert the DC plug of the adaptor into the DC Jack on the
unit
2.) Plug the Adaptor plug into an outlet rated at 120V~ 60Hz. characters
7
