Jensen JiPS-310i, User Manual

REMOTE CONTROL 

Remove the insulation tab from the battery compartment to activate the remote before first use. 
When the operation of the remote control becomes intermittent or the effective distance is significantly 
decreased, replace the exhausted battery with a fresh type CR2032 3V   lithium battery as follows: 
1. 

Open and take out the Battery Compartment Cover from the remote control. 

2. 

Replace the weak/dead battery with a new one.    Be sure the fresh battery is installed correctly as 
shown below. The remote will not work if the battery is installed with wrong polarity. 

3. 

Snap in the Battery Compartment Cover into the battery compartment to close. 

BATTERY NOTE AND CARE 

Š

Danger of explosion if the battery is replaced incorrectly.    Replace only with the same type battery. 

Š

Only use a good quality known brand battery to ensure the longest life and best performance. 

Š

If the remote is not to be used for an extended period of time, remove the battery.    An old or leaking 

battery can cause damage to the remote and may void the warranty. 

Š

Do not dispose of batteries in fire. Batteries may leak or explode. 

Š

Do not try to recharge batteries that are not intended to be recharged; they can overheat, rupture and 

leak (Follow battery manufacturer’s directions). 

Š

Only an adult should replace the battery. 

WORKING WITH AN iPad / iPhone / iPod 

CHARGING YOUR APPLE DEVICE 

Even if the main unit is in standby mode, once your iPad, iPhone, iPod touch or iPod nano is docked onto the 
Docking Connector, the charging will start automatically until the battery is full.   

 
LISTENING TO MUSIC ON YOUR APPLE DEVICE 

This unit works with the listed models of iPad, iPhone, iPod touch and iPod nano. 
1. 

Dock your Apple device carefully and securely onto the Flexible Docking Connector. 

2. 

Tap the Power Button on the remote or Play/Pause Button on the main unit to turn on the unit.    The red 

Power/Mode Indicator will turn blue.    Use the Mode Button on the remote to switch the main unit to 
iPod mode if necessary. 

3. 

Select the “Music” function on your Apple device to access your music library.    Auto playback of iPod 

music is not supported on this product. 

4. 

After selecting your favorite song, tap the Play/Pause 

  Button on the remote or on the main unit to 

pause or play. 

5. Tap 

the 

  Button on the remote or the same button on the main unit to advance to the next song.   

Press and hold the 

  Button on the remote during playback for fast forward search within the song. 

6. Tap 

the 

  Button on the remote or the same button on the main unit to skip back to the previous 

song.  Press and hold the 

  Button on the remote during playback for fast backward search within 

the song. 

7. 

Press the Volume Up (+) or Volume Down (-)on the remote to adjust the volume output level. 

Press and hold the 

 and 

 Buttons on the main unit can also increase and decrease the 

volume output level. 

8. 

If you want to repeat a song, press the Repeat Button on the remote once.    To repeat the entire album 

or playlist, press the Repeat Button one more time.    The respective repeat 1/All icon on your Apple 
device screen will change accordingly. 

9. 

Press the Mute Button to cut off the audio output from the speakers momentarily.  Press again to 

resume listening. 

JiPS-310i User Manual (English), P.6