Jensen JISS-300I, User Manual

10



After all the programmed tracks have been played, the player stops but the programmed tracks 
remain in the memory. 



Press the PROGRAM Button followed by the PLAY/PAUSE     Button to begin programmed 
playback again.   

7. 

To cancel programmed play, in Stop mode press the STOP 

■

 Button once or open the CD DOOR.  

8.   To turn the CD player off, set the FUNCTION selector to STANDBY/AUX position. The LCD 

backlight will go off.    

LISTENING TO YOUR iPod/iPhone 

1.  Gently push the iPod/iPhone compartment door to open it. The door will automatically open. 
2.  Place your iPod/iPhone into the docking port by placing the connector on the bottom of the 

iPod/iPhone onto the connector in the docking bay. When the system is powered by AC, 
iPod/iPhone battery charging will start automatically even if the Dock is in standby mode. 

Note: 

(1).

Please be careful when seating the iPod/iPhone into the docking to avoid damaging the 

30-pin connector on the iPod/iPhone or in the Docking System.  Dock your iPod/iPhone 
carefully into the 30-pin connector and then close the door.  

(2). The iPod/iPhone will only be charged when the System is powered by AC.                              

3.  Close the iPod/iPhone compartment door, set the FUNCTION selector to the iPod/iPhone position, 

the LCD backlight will light and display the message “iP”.             

4.  Press the PLAY/PAUSE   button to start play back.

5.  Select the previous or next music tracks by pressing the B-SKIP 



 or F-SKIP 



 Buttons 

repeatedly, and press the PLAY/PAUSE

 Button to play or pause. 

Note:

 The System’s LCD will not show any music information (e.g. song name) for your 

iPod/iPhone. Please view the music information through your iPod/iPhone display. 

6.  Adjust the sound level using the VOLUME control. 

        Note: 

The volume level cannot be adjusted using the volume control on your iPod after docking.

7.  To remove the iPod/iPhone from the unit, press and hold the PLAY/PAUSE

Button on the 

System for a few seconds to switch off the device, open the iPod/iPhone compartment door and 
then gently remove it from the dock connector. 

8.  To turn the iPod/iPhone mode off, set the FUNCTION selector to STANDBY/AUX position. The 

LCD backlight will go off.    

iPod/iPhone playback control: 



Press the iPod/iPhone

PLAY/PAUSE

 button to pause or resume the iPod/iPhone 

playback; 



Press the SKIP 

 or 

  buttons to skip to the next or previous song; 



Press and hold the SKIP 

 or 

  buttons for fast-forwarding or fast-rewinding during 

playback. 



From the remote, press the 

MENU

 button, 

ENTER

 button and 



/



 buttons on the remote