11
iPod/iPhone playback;
Press the
SKIP
or
buttons to skip to the next or previous song;
Press and hold the
SKIP
or
buttons for fast-forwarding or
fast-rewinding during playback.
Press and hold the PLAY/PAUSE
/
M
button for 3 seconds to control
iPod / iPhone screen menu.
Tap the ENTER button to enter iPod/iPhone menu selection.
Press the
/
buttons to scroll iPod/iPhone menu up/down
Note:
1. The remote control only turns on and off the Docking Base. The
left and right satellite speakers must be turned on/off manually
using the power switch located on back of each speaker box.
2. The volume of satellite speakers are default set to maximum
when the speaker power is on.
PLAYING MUSIC FROM YOUR COMPUTER
To play music from a Windows or Mac OS X based personal computers.
NOTE:
1. The volume of satellite speakers are default set to maximum when the speaker
power is on.
2. When you playing music from your computer, the volume control on Docking
Base and remote control will not work. Please use the volume control on your
computer or the volume buttons on the wireless speakers to control the sound
level.
Windows Based Computer (for Windows XP or above)
1.) Remove the USB Transmitter from the back of the Docking Base and plug it
into the USB port of your computer. The computer reports “Found New
Hardware” the first time the USB port is accessed. Wait for the computer to
automatically search and install the necessary device drivers for the USB
Transmitter. Once installed, the PC will show “Your new hardware is installed
and ready to use” when the device drivers have been properly installed.
2.) Go to your computer control panel and set the default audio sound playback
device to the “SYNIC Wireless Audio”.
3.) Fully charge and place the two speakers within wireless range of the
transmitter that is plugged into the USB port of your computer.
4). Link the wireless speakers by following linking instructions mentioned in the
“Getting Start” section of the manual. Now you can play music from your PC
