REMOTE CONTROL BATTERY INSTALLATION
The remote control operates on one CR2025 battery (included). To activate the remote
control, remove the insulation tab inserted in the battery compartment. To remove the tab,
pull it in the direction of the arrow in the illustration as shown.
When the operation of the remote control becomes intermittent
or unsatisfactory, replace the original battery with a new 3-volt
lithium battery.
Replacing the battery in the remote control:
1.) Press in on the side of the battery holder and pull the
holder out of the remote.
2.) Removed the exhausted battery and then install 1 new “CR2025” lithium
battery according to the polarity diagram on the battery compartment.
3.) Insert the battery holder into the remote control and make sure it locks
into place.
NOTE: Only use a well-known brand of battery to ensure the longest life and best
performance.
Battery Precautions
Replacement of batteries must be done by an adult.
The supply terminals are not to be short-circuited.
Non-rechargeable batteries are not to be recharged.
Exhausted batteries are to be removed.
Only batteries of the equivalent type are to be used.
Batteries are to be inserted with the correct polarity.
Dispose of batteries properly. Do not dispose of batteries in fire. The batteries may
explode or leak.
Notes:
The remote may not operate properly if there is an obstacle
between the unit and the remote transmitter.
The remote may operate intermittently if operated in direct
sunlight, under bright incandescent lamps, fluorescent lamps
or any other strong light source.
7
