9
Replacing the battery in the remote control:
1.) Press in on the side of the battery holder and pull the holder out of the remote.
2.) Removed the exhausted battery and then install 1 new “CR2025” lithium
battery according to the polarity diagram on the battery compartment.
3.) Insert the battery holder into the remote control and make sure it locks into place.
NOTE:
Only use a well-known brand of battery to ensure the longest life and best
performance.
BLUETOOTH OPERATION
PAIRING (LINKING) A BLUETOOTH ENABLED CELL PHONE OR OTHER
BLUETOOTH ENABLED DEVICE to the JSB-200
1. With the power on, press the SOURCE button on remote control or tap the
/SOURCE button on main unit repeatedly to select Bluetooth mode. The Mode
Indicator LED turns blue and will be flashing. The JSB-200 is now ready to pair
(link) with your Bluetooth device.
2. Turn on the Bluetooth feature of your cell phone and enable the search or scan
feature to find the JSB-200.
3. Select "JSB-200" from the device list when it appears on your device screen. If
required, enter the pass code “0000” to pair (link) the JSB-200 with your cell
phone.
4. After successfully pairing (linking) your cell phone with the JSB-200, the Mode
Indicator LED stops flashing and remains lit blue. You can now play music from
your cell phone or Bluetooth device wirelessly to the JSB-200.
Battery Precautions
z
Replacement of batteries must be done by an adult.
z
The supply terminals are not to be short-circuited.
z
Non-rechargeable batteries are not to be recharged.
z
Exhausted batteries are to be removed.
z
Only batteries of the equivalent type are to be used.
z
Batteries are to be inserted with the correct polarity.
z
Dispose of batteries properly. Do not dispose of batteries in fire. The batteries
may explode or leak.
