11
Re-linking to a cell phone or Bluetooth device
If your cell phone or Bluetooth device is already paired with the JSB-200, but became
unlinked at some point, even with both Bluetooth devices turned on. You can re-link
them by:
1. Press and hold the PAIR
button
to re-link your cell phone. The Mode Indicator LED
will turn blue and flash while linking.
2. Select the JSB-200 from the devices list on your cell phone for linking. The Mode
Indicator LED stops flashing and remains lit blue if the JSB-200 and your cell phone
have been re-linked successfully.
3. You can also re-link the JSB-200 by using Bluetooth operation of your cell phone.
Please refer to operation manual of your cell phone for more information.
PRESET EQ (REMOTE CONTROL ONLY)
The JSB-200 features 5 different EQ modes to enhance your listening experience. You
can select the desired effect by pressing the “EQ” button on remote control repeatedly
at following sequence:
NORMAL
JAZZ
POP
CLASSIC
ROCK
In addition, you can adjust treble and bass effects by using the TREBLE & BASS +/-
buttons.
MUTE (Remote Control Only)
- Press the MUTE
button on remote control to mute the sound output from
speaker temporarily, the Mode Indicator LED will flash.
- Press the
button again to resume to normal speaker playback.
SUBWOOFER OUTPUT
The JSB-200 features a subwoofer output jack that allows you to connect an external
amplifier (such as a 2.1CH amplifier or a 2.1CH micro system) or amplified subwoofer
(not included) via the SUBWOOFER OUT jack located on the back of the unit. Follow
the steps below to connect the external amplifier or subwoofer:
1. Use an RCA audio cable (not included) to connect the SUBWOOFER INPUT of your
external amplifier to the SUBWOOFER OUT jack on the back of the unit.
2. Power on the unit and the external amplifier.
3. When audio is playing from the JSB-200, the deeper bass signals will be played
through the external amplifier at the same time enhancing the bass sound effect.
