E10
RADIO OPERATION
MANUAL TUNING
1. Press the POWER button on main unit to turn on the unit. The display will show “HELLO” and
then “---bUSY” for few seconds. Wait until the display shows FM frequency. The unit is in FM
mode.
2. Tap the “FM/AM”
button to select AM Radio mode if necessary.
3. To manually tune to a specific radio station, tap the “
/TUNE” or “TUNE/
”
button on
either the main unit or the remote control repeatedly. Use the manual tuning method to tune
in weaker stations that are bypassed during Automatic Tuning.
4. To automatically tune to the next available radio station, press and hold the “
/TUNE” or
“TUNE/
”
button for 1-2 seconds until frequency readout on the display begins to scan and
then release the button. The tuner will stop scanning when it receives the next broadcasting
station of adequate signal strength.
5. Rotate the VOLUME control knob on main unit or press the “VOL+/-“
b
utton on the remote
control to adjust the volume to the desired volume level.
FM & FM-STEREO RECEPTION
Tap the “FM/AM” button to select FM radio mode if unit is in AM mode. When listening to the
FM radio, press the “
/
ST./MONO” button to switch between stereo mode and mono mode.
The FM stereo icon “
” will appear on the display if unit is in stereo mode.
We recommend leaving the unit in mono mode if you are receiving a weak FM station.
HINTS FOR BEST RECEPTION:
AM -
The AM antenna is located inside the cabinet of the unit. If AM reception is weak,
change the position of unit until the internal antenna picks up the strongest signal.
FM -
For best FM reception, the FM lead wire antenna located on the back of the set
should be fully unwrapped and extended.
NOTE
: Automatic tuning depends on the signal strength of the broadcasting station, so weak
stations may be skipped. You can manually tune to find the weak stations if a station gets
skipped. With strong signals, the tuner may stop before it reaches the actual broadcast
frequency, so you may need to manually tune for the best reception.
PRESET RADIO STATIONS
You can store up to 30 FM + 30 AM radio stations in the memory.
1. Press the POWER button to turn on the unit, wait until the display shows the FM frequency.
2. Tap the “FM/AM” button to select AM band if necessary.
3. Tune to a desired radio station by using either the “manual” or “automatic” tuning method.
4. Tap the “PROGRAM” button to enable the program mode and the “PROGRAM” indicator and
“P - -01” appear on the LCD display.
5. Tap the “
/
”
button on remote control or main unit repeatedly to select the desired station
memory for storage.
6. Tap the “PROGRAM” button again to confirm the setting.
7. Repeat steps 3 through 6 to preset other stations if necessary.
NOTES:
1.) The unit will remain in program mode for about 40 seconds if no buttons are pressed. After
the 40 seconds expires, the unit will return to normal tuner mode automatically.
2.) You can overwrite a present station by storing another frequency in its place.
RECALLING PRESET MEMORY CHANNELS
In AM or FM radio mode, recall the pre-set channels by repeatedly pressing the
“FOLDER/PRESET UP/DOWN” button
on the remote control or on the main unit.
