Jensen JWM60A, Installation And Owner'S Manual

JWM6

0A

.

INSTALLATION

It's a good idea to read all of the instructions before beginning the installation. 
We recommend having your Jensen JWM60A installed by a reputable RV 
dealership.

NOTE: If the JWM60A is to be installed in a vehicle equipped with an on-
board drive or navigation computer, do not disconnect the battery cable. If 
the cable is disconnected, the computer memory may be lost. Under these 
conditions, use extra caution during installation to avoid causing a short 
circuit.

NOTE: Before cutting the mounting hole, make sure the area behind the 
mounting location is clear of wires, fuel and vacuum or brake lines.

You will need these tools and supplies to install your JWM60A:

Select a mounting location, taking care to avoid the following:

To prevent a short circuit, be sure to turn off the ignition and remove the negative 
(-) batterycable prior to installation.

Ÿ

Phillips screwdriver

Ÿ

Wire cutters and strippers

Ÿ

Tools to remove existing radio (screwdriver, socket wrench set or other tools)

Ÿ

Electrical tape

Ÿ

Crimping tool

Ÿ

Volt meter/test light

Ÿ

Crimp connections

Ÿ

16 gauge wire for power connections

Ÿ

16 –18 gauge speaker wire

Ÿ

Four M3x20mm (3/32 x 0.75") screws

Ÿ

Places exposed to heat-radiating appliances such as electric heaters

Ÿ

Adjacent to other equipment that radiates heat

Ÿ

Poorly-ventilated or dusty places

Ÿ

Moist or humid locations

Tools and Supplies

Disconnecting the Battery

Selecting the Mounting Location

Preparing the Opening

9

.

30"

0

.

6"

9

.

76"

 0

.

6"

+

+

+

+

+

+

+

6.11"   0.6"

4

.

68"    0.6"

.75"   0.6"

.23"    0.6"

MOUNTING SCREWS M3 X 
20 PHILLIPS TYPE ROUND 
HEAD 4 PLACES

R.19"   0.6"
4-PLCS.

5

Use the mounting hole diagram(below) to measure and cut a mounting hole, 
then mount the unit using four M3x20mm screws.