Warning - Existing Data Will Be Overwritten
This warning message is displayed when the user attempts to save a spectrum scan or quantitation
calibration curve and previous data has already been stored. The instrument can store two scans and
quantitation calibration curves, but must over write the oldest stored data if a subsequent scan or
calibration curve is stored. This warning message can be disabled.
No Data Stored at this Location
Up to two scans can be sequentially stored in memory. This warning is displayed when the user
attempts to recall a scan from one of the memory areas (locations) which does not hold a previously
stored scan. The message is displayed for information only: no corrective action is required.
No Data to Print
This warning is displayed when the user attempts to print a blank graph from spectrum, kinetics or
quantitation mode.
e) Multi-Wavelength Mode - please refer to a)
f) Kinetics Mode
No Data to Print
This warning is displayed when the user attempts to print a blank graph from spectrum, kinetics or
quantitation mode.
Invalid Slope Range
This error is reported when the user selects an invalid region of a kinetics run for the line of best fit.
For example, when the line of best fit end point is set to be less than the line of best fit start point. The
error is automatically corrected.
No Data to Acquire Statistics
This error is displayed if the user attempts to view statistics with no scan or kinetics run data.
g) Quantitation Mode
Warning - Existing Data Will Be Overwritten
This warning message is displayed when the user attempts to save a spectrum scan or quantitation
calibration curve and previous data has already been stored. The instrument can store two scans and
quantitation calibration curves, but must over write the oldest stored data if a subsequent scan or
calibration curve is stored. This warning message can be disabled.
No Data Stored at this Location
Up to two scans can be sequentially stored in memory. This warning is displayed when the user
attempts to recall a scan from one of the memory areas (locations) which does not hold a previously
stored scan. The message is displayed for information only: no corrective action is required.
No Data to Print
This warning is displayed when the user attempts to print a blank graph from spectrum, kinetics or
quantitation mode.
640 050/REV B/11-99
40
