７
APPENDIX
TMPM5200-2
7-1
7.1 WINSPM SOFTWARE REINSTALLATION METHOD
Below is the method of re-installing the WinSPM software.
7.1.1 Before Re-installing the WinSPM Software
Reconfirmation of trouble
Before re-installing the software, check the cause of the trouble once again, and if
possible, eliminate it.
If the hard disk of the computer is nearly full, make a backup copy of the recorded
measurement data, then erase the data from the hard disk to free some space. Particularly,
be sure to set aside sufficient space on the hard disk where the WinSPM system is
installed.
If devices that are not part of the WinSPM are installed in the computer, remove all of
them. Also, if software other than the WinSPM software is installed in the computer,
uninstall all of it.
•
Component parts of the WinSPM system (computer system)
•
Computer proper
•
Display monitor
•
Keyboard/mouse
•
A/D board
•
WinSPM system software
Checking the calibrated values of the scanner sensitivity and the motor drive
position
Before re-installing the WinSPM software, confirm that the calibrated values of the
scanner sensitivity and the motor drive position have been recorded.
Refer to Sect. 7.2.2 and 7.2.3.
After re-installing the software, it is necessary to record those values in the reinstalled
WinSPM software once again.
Items needed when reinstalling the software
Before re-installing the SPM software, obtain the following items.
•
Windows installation CD-ROM and its manual that came with the computer
•
Computer manuals and device driver installation disk
•
WinSPM software installation CD-ROM
•
CD-ROM (OmniCD ) that came with the A/D board
Some personal computers come with a recovery CD instead of a Windows
installation CD-ROM.
