５
MEASUREMENT OPERATION
5-166
TMPM5200-2
5.9 TERMINATING
OPERATION
mination procedure.
1.
Select File from the main menu and select Exit from the pull-down menu.
2.
Confirm that
y data has been saved on a disk, and click on the
OK button.
If data is still in the computer memory, a warning message appears in the window.
3.
Confirm that the SPM software has been terminated and the screen has
returned to Windows
TM
.
4.
Move the cursor to the bottom-left corner of the screen and click on the Start
button; then click on the Shut Down button from the pop-up menu.
5.
Select Shut down the computer?; then click on the YES button.
The computer is turned off.
After saving the desired data on a disk upon completing image observation, you
terminate the system. The following is the ter
all necessar
6.
Turn off the POWER switch of the SPM CONTROL unit.
POWER
switch
7.
C
—— C
The software must be terminated before the power is turned off. Never
turn off the power while the software is in operation.
Wait 10 seconds or more before restarting the system.
SPM
CONTROL unit
onfirm that the power to all the units is completely off.
AUTION ———————
