JEPSDN
'!'!/t�f'
®
II\
�
_
9
6.2. Replacing the saw blade
The blade can be replaced easily by following these instructions:
Step 1
Pull the power supply plug from the socket. Next, put the plug aside so that it cannot
be plugged in accidentally.
Step 2
(Fig. 5)
Loosen the butterfly screw (A), turn the small cover (B) to the rear, pull up the
vibration dampers (C)
, and lock them by turning them to the side.
Step 3
(Fig. 6&7)
Push in spindle lock (Fig. 6-A). Grip the screw with the hexagonal wrench and
loosen the screw. Turn the face cover up and carefully remove the blade.
Step 4
(Fig. 7)
Push the new blade carefully onto the axle
shaft, ensuring that the rotation direction
indicated on the saw blade runs counter-clockwise and the saw blade is grease-free.
Also ensure that the blade rotates in the direction indicated by the arrow on the
protective cover. Next, replace the external flange and the screw and tighten firmly.
Step 5
Turn the small cover back to its original position and tighten the butterfly screw (Fig.
5-A). Move the vibration dampers back to their original position by turning them
(Fig. 5-C).
Step 6
Loosen the spindle lock and ensure that the saw blade can ro
t
ate freely (Fig. 6).
