2
General Description
Given the bottle is full of liquid during normal spraying, if the spray volume is
reduced, the filter may be blocked and it needs to be replaced; if the atomization
effect of spray is getting poor or the nozzle does not perform the spraying, the
nozzle may be blocked and it needs to be cleaned.
Instructions of Filter Replacement
Steps
1. Unscrew the bottle, rinse the outer surface of liquid suction hose and filter with
clean water, therefore removing the liquid on suction hose and filter. Add
400mL of clean water to the bottle, install the bottle, turn on the sprayer, and
spray clean water to flush the liquid inside the liquid hose.
2. Unscrew the bottle counterclockwise, and pull out the entire suction hose
assembly by hand according to the following diagram.
Note
a.
The installation direction is that the fine filter (Part 1) is on the top and the
coarse filter (Part 2) is at the bottom (flat ends of coarse filter and fine filter are
the liquid inlet, and the flat ends are all facing down).
b.
If the replacement is required, the coarse filter and the fine filter must be
replaced at the same time.
c.
Only the filter recommended by the manufacturer can be used, otherwise it will
cause poor liquid suction or frequent nozzle blockage, or even reduce the
service life of liquid pump.
d.
During the replacement process, always keep hands and parts of suction hose
