Ƶ
Important-Safety Precautions
x
To prevent fire or shock hazard, do not expose this device to rain or moisture.
Does not use near a bathtub, washbowl, kitchen sink, or laundry tub, in a wet
basement, or near a swimming pool.
x
To avoid electrical shock, do not open this device.
x
This
device
should be operated to use only the power supply included with it
or provided as an accessory.
x
Do not overload wall outlets and extension cords as this can result in the risk
of fire or electrical shock.
x
Do not attempt to service this device yourself. Refer servicing to qualified
personnel only.
Caution:
Changes or modifications not expressly approved by the
Party responsible for compliance could void the user’s authority to
operate the equipment.
1
A. Checking Contents of Box
Checks and make sure that all of the items shown as below are included with
your 2.4 GHz Digital Wireless A/V Sender System. If something is missing,
please contact your dealer as soon as possible.
1.
Transmitter
h
1
2.
Receiver
h
1
3.
Power adapter (optional)
h
2
ƶ
(120VAC to 5VDC)
DC in Jack ( 5V 1A)
4.
IR extender
to connect to transmitter
h
1
5.Connector cables (Optional)
h
2
ƶ
3RCA plug to 3RCA plug AV cable
6.
Owner’s manual
h
1
2
NOTE: This equipment has been tested and found to comply with Part
15 of the FCC Rules, or R&TTE CE directive. These limits are designed
to provide reasonable protection against harmful interference in a
residential installation. This equipment generates, uses and can radiate
radio frequency energy, if not installed and used in accordance with the
instruction, it may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful interference
to radio or television reception, which can be determined by turning the
equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
x
Reorient or relocate the receiving antenna.
x
Increase the separation between the equipment and receiver.
x
Connect the equipment into an outlet on a circuit different from that to
which the receiver is connected.
x
Consult the dealer or an experienced radio/TV technician for help
IMPORTANT NOTE: To comply with the FCC RF exposure compliance
requirements, no change to the antenna or the device is permitted. Any
change to the antenna or the device could result in the device exceeding the
RF exposure requirements and void user’s authority to operate the device.
