·
Connect the receiver directly to the remote TV.
·
Connect the receiver to a VCR, which is then connected to the TV.
If your TV has picture-in-picture capabilities, you can view any image
transmitted by sender, such as your sleeping baby, in a small inset picture
while enjoying other programming on the rest of the screen. Consult the
owner's manual of your TV for instructions on using these capabilities.
Connecting Receiver Directly to Remote TV
Connect TV and receiver with RCA cable, just plug RCA plugs to receiver
RCA sockets.
If your TV has only SCART socket for audio/video input, you can use a
SCART/RCA adapter (not included) to connect the RCA plug of the
transmitter and the SCART socket of TV. Please follow the instruction figure
below.
11
Ƶ
Connecting Receiver to Remote TV through VCR
This setup enables you to record transmitted audio and video on your remote
VCR and also enjoy the picture and sound on a remote TV at the same time.
1. Connect VCR and receiver with RCA cable, just plug RCA plugs to the
RCA input of VCR. If your VCR has only SCART socket for audio/video
input, you can use a SCART/RCA adapter (not included) to connect the RCA
plug of the transmitter and the SCART socket of TV. Then connect TV and
SCART output of VCR using a “SCART to SCART A/V CABLE” (with must
be purchased additionally). Please follow the instruction figure below.
2. If your TV has A/V input jacks, connect another set of A/V cables to the
TV's A/V input jacks and to the A/V output jacks on your VCR.
3. If your TV does not have any A/V input jacks, please connect a 75ohm
coaxial cable (not included) from the TV's antenna in (or RF in) to VCR's
modulator output.
This feature is optional
4.
Plug one end of the sender power adapter into the back of the receiver and
the other end into any AC wall outlet.Use only the adapter provided.
5.
Locate and orient the receiver to best video and sound quality please
according to the section of this manual titled "Orienting Units for optimum
Performance".
12
