Problem
Possible solutions
No picture or sound
x
Check all cable connections.
x
Make sure power plugs are pushed all the way in.
x
Check power switches on the remote TV and
Video source. (VCR, laser disc player, satellite
receiver, ect. )
x
Check the power on/off switches on the
transmitter and receiver.
x
Check if the LINK LED of the transmitter and receiver is
lighting or not? Their LINK LED should be lit.
x
If Their LINK LED should not be lit, you can try to re-pair
your code, but you have to comply with the user manual
instructions to the matching code.
Interference:
picture or audio
x
Adjust receiver and transmitter antenna orientation. ( see
section on "Orienting Units for Optimum Performance"
in this manual )
x
Try to place transmitter and receiver in a more close-in
location.
x
If using a microwave oven, turn it off.
x
Remove microwave oven from path between
transmitter and receiver.
Remote control
extender does
not work
x
Check the path between the transmitter and the
audio/video source and clear any obstructions.
x
Check to see if the IR window on the bottom
front of the transmitter is blocked.
x
Make sure IR extender is properly rotated in the
A/V equipment you wish to control.
Note:
Clean the outside plastic packaging with a soft cloth lightly moistened
with mild soap and water. Never use any abrasive scouring powder
or solvent.
15
H. Specifications
Transmitter:
Operating Frequency Band 2.400GHz~2.4835GHz
Maximum Transmit Power 50mW
Modulation 16QAM/QPSK/BPSK
Video Input Level 1V p-p
˜
75 ohm
Audio Input Level 1V p-p
˜
600 ohm
(STEREO)
Antenna Omni-directional
IR–remote IR output 940nm with ON/OFF keying
Power consumption 1.9W
Power supply 5V/1A
Dimension(L x W x H) 148mm*99mm*29mm
Weight 160g
Receiver:
Operating Frequency Band 2.400GHz~2.4835GHz
Receiver Sensitivity -80dBm min.
Video Output Level 1
f
V p-p
˜
75 ohm
Audio Output Level 1
f
V p-p
˜
600 ohm (STEREO)
Antenna Omni-directional
Power consumption 1.9W
Power supply 5V/1A
Dimension 148mm*99mm*29mm
Weight 162g
System:
Video bit rate up to 12 Mbps
Random ID code up to 4 million sets
Video resolution 720 x 480 @ 30 fps (NTSC) or 768 x 576 @
25 fps (PAL)
Operational range up to 100 meter (line of sight)
Remote control range up to 100 meter (line of sight)
Ɣ
All specification subject to change without notice
16
IMPORTANT NOTE: To comply with the FCC RF exposure compliance requirements,
the antenna(s) used for this transmitter must be installed to provide a separation
distance of at least 20 cm from all persons and must not be co-located or operating in
conjunction with any other antenna or transmitter. No change to the antenna or the
device is permitted. Any change to the antenna or the device could result in the
device exceeding the RF exposure requirements and void user’s authority to operate
the device.
