January, 2009
24
In order to do it, move to the menu screen, press
“radio” submenu and you get to the adjust screen.
This first menu is only informative and it warns you of
the entrance in the screens of programming of the
throttle control. Press the button 'Data Up' to enter in
the programming menus. Next it appears the screen of
programming the full throttle position.
In order to program these parameters locate the trim
and stick in the superior position. Once located in this
position, push the button "Data Up". At this moment
the
I.C.S.
will record the received order of the radio as
the position of full power and, in the HDT, the following phase of adjustment is shown. If this
adjustment requires no modifications, is enough to push the key "Menu up". This also causes
the change of screen but the throw is not
programmed.
The following screen allows programming the lower
limit (Stop). In order to do it is enough to locate the
trim and stick to the minimum and push the button
"Data Up”. Also in this case pushing the button “Menu
up” will cause the change of screen without varying
the previous adjustment.
The last screen of adjustment is the position of the
trim that will correspond to the idle of the engine. To
make this adjustment it is enough to locate the stick
to the minimum and the trim to maximum and push
the button “Data Up”. Just as in the previous
adjustments, the button “Menu up” will cause the
change of screen without varying the last recorded
adjustment.
Once finished the programming of the transmitter, it
can be verified by means of the secondary screen of the HDT.
To the right of the value of the transmitter’s received pulse appears one from 0 to 100%. This
value must correspond to the relative position of the throttle stick, matching 0% to stick and
the trim to the minimum and, 100% to stick and trim to the maximum. If these values were not
reached, or the limits of the 0 or 100% were reached before pushing the stick to the end, the
calibration process must be repeated.
When the superior and inferior limits are verified, the adjustment of the trim can be verified.
This is made through the green LED that incorporates the
I.C.S.
Summary of Contents for Rabbit
