9
Assembly
Tools required for assembly:
Hoist, forklift, or one or more assistants
Wrenches – 9/32”, 1/2” , 9/16”
Hex wrenches – 4mm, 1/8”
Install Stand Legs
The sander is heavy; use
caution when lifting.
1. Raise the sander from the floor using a forklift,
hoist or an assistant. Place hoist straps through
the
carriage arm
(see
Features
on page 7) or
below the table mounting brackets. If using a
forklift, place fork below the
table mounting
brackets
(see
Features
on page 7).
Referring to Figure 1:
2. Position the
assembly fixtures
(Z
1
) below the
columns
so that the wider part of the
plywood
(Z
2
) faces outward. Lower the sander
columns
into the
assembly fixtures
.
3. Mount
the
four
legs
(R) to the
columns
, using
four each 3/8x1-1/2
hex cap screws
(A), 3/8
flat
washers
(H) and 3/8
flanged lock nuts
(E),
Tighten flanged nuts securely with 9/16”
wrench, making sure the
legs
(R) remain in
contact with the
plywood
(Z
2
).
4. Lift the sander and remove the
assembly
fixtures
(Z
1
, Z
2
).
Referring to Figure 2:
5. With the sander raised, install
casters
(W) to
legs
(R). First lock the caster by pressing the
large tab to remove the
hex nut
(F) and
flat
washer
(G).
Table Support Screws
The
set-screws
on the
table supports
(Figure 3)
have been tightened at the factory to eliminate free-
play between the table supports and the columns
during shipment.
All four set-screws must be
loosened and re-adjusted before operating
either the height adjustment mechanism or the
conveyor drive.
Proceed as follows:
Failure to follow the below
procedure may result in misalignment of the
drum and/or conveyor bed, or may damage the
miter gears.
1. Loosen each hex nut with an open-end wrench,
then loosen the
set-screw
with a hex wrench.
2. Re-tighten
the
set-screw
with your fingers
until
it only lightly touches the column tube.
3. Hold the
set-screw
in position with the hex
wrench, and re-tighten the
hex nut
.
Figure 1
Figure 2
Figure 3
Summary of Contents for 22-44 Pro-3
Page 35: ...35 Stand Assembly...
Page 37: ...37 Drum Head Assembly...
