8
Fig 16
Do not file the outside edges of the
spur as this will affect the diameter of
the bit.
8. Maintenance and inspection
General notes:
Maintenance, cleaning and repair
work may only be carried out after
the machine is protected against
accidental starting by pulling the
mains plug.
Clean the machine regularly.
Periodically oil any exposed machine
surfaces.
Defective safety devices must be
replaced immediately.
Repair and maintenance work on the
electrical system may only be carried
out by a qualified electrician.
9. Trouble shooting
Motor doesn’t start
*No electricity-
check mains and fuse.
*Defective switch, motor or cord-
consult an electrician.
Chisel clogged with chips
*Clearance chisel to bit not enough-
see chapter 7.1.
*chips cannot clear the chisel-
observe chisel slot and working order.
Burned wood
*
Feed too slow-
increase feedrate.
*Worn chisel or bit-
sharpen chisel and bit.
10. Available accessories
Stock number 708597
Closed stand with mobile base and
tool rest
Refer to the JET-Pricelist for chisels
and bits in various sizes.
