14
Dust Collection
1. Hook the sander to a dust collector using a 4”
diameter hose and clamp (A, Fig. 16). JET
offers a wide variety of hoses, adapters and
dust collectors.
2. Loosen the wing nut (B, Fig. 16) and pull the
gate (C, Fig. 16) open to allow air suction to
the sanding belt. Push the gate closed to shut
off air suction. Tighten the wing nut.
3. Push the gate (D, Fig. 16) down to shut off air
suction to the disc. Lift the gate to open the air
suction to the disc.
Maintenance
Keep the exposed metal surface of the disc table
clean and free of rust. Use a light coat of paste
wax to protect the surface.
Lubrication
All moving parts run on sealed ball bearings and
require no lubrication.
Figure 16
Optional Accessories
708596 Open Stand with Belt Rack
708597 Closed Stand with Belt Rack
Dust Collectors and Accessories: see your JET Distributor
