7
Installation
Tools required
Drill with 5/16" drill bit
10mm open end wrenches
Cross point screwdriver
Adjustable square
Hammer (or rubber mallet)
Straight edge
The following instructions are for installing the
XACTA Fence II and Rail System
on JET Models
JWCS-10 and JWTS-10 series table saws.
Front Rail Installation
Referring to Figures 1:
1. With a 5/16” drill bit, drill out the two threaded
holes on the
table front
(C).
Note:
By drilling out the threads you will gain
the needed room for adjustment of the front
rail.
2. Identify the
front rail
(A), which is 2” x 2” with
slots running along each side.
3. Align the slots on the
front rail
to the four holes
in the front edge of the saw table (Figure 1).
Referring to Figure 2:
4. Lightly secure the
front rail
to the
saw table
and extension wings with four 1/4-20 x 1-1/2
hex cap screws, eight 1/4” flat washers, four
1/4” lock washers, and four 1/4” hex nuts.
Tighten just enough to hold the rail next to the
table but keep loose enough to allow height
adjustment.
The
front rail
must be 2-3/16" down from the table
top in order to function properly.
5. Place an adjustable square on the table as
shown in Figure 3.
6. Check the height of the
front rail
at several
locations along the surface of the saw table.
The front rail
must
be parallel with the table
top.
7. When the
front rail
has been correctly
positioned, tighten all mounting screws
securely with two 10mm wrenches.
Figure 1
Figure 2
Figure 3
