Jet 892100 Operating Instructions And Parts Manual Download

Page: 6 / 68

1700 Series Lathe

4.0 INTRODUCTION

This manual is provided by JET

covering the safe operation and maintenance procedures for a JET Model EGH-1740

and EGH-1760. This manual contains instructions on installation, safety precautions, general operating procedures,
maintenance instructions and parts breakdown. Your machine has been designed and constructed to provide years of
trouble-free operation if used in accordance with the instructions as set forth in this document.

If there are questions or comments, please contact your local supplier or JET. JET can also be reached at our web site:
www.jettools.com. Retain this manual for future reference. If the machine transfers ownership, the manual should accom-
pany it.

Familiarize yourself with the following safety notices used in this manual:

This means that if precautions are not heeded, it
may result in minor injury and/or possible machine
damage.

This means that if precautions are not heeded, it
may result in serious injury or possibly even death.

24. Use the right tool at the correct speed and feed rate. Do not force a tool or attachment to do a job for which it was not

designed. The right tool will do the job better and more safely.

25. Use recommended accessories; improper accessories may be hazardous.
26. Maintain tools with care. Keep cutting tools sharp and clean for the best and safest performance. Follow instructions

for lubricating and changing accessories.

27. Do not attempt to adjust or remove tools during operation. Disconnect tools before servicing; when changing

accessories, such as blades, bits, cutters, and the like.

28.  Never stop a rotating chuck or workpiece with your hands.
29.  Choose a low spindle speed when working unbalanced workpieces, and for threading and tapping operations.
30.  Do not exceed the maximum speed of the workholding device.
31.  Do not exceed the clamping capacity of the chuck.
32.  Secure Work. For safety and use of both hands, use clamps or a vise to hold work when practical.
33.  Workpieces longer than 3 times the chucking diameter must be supported by the tailstock or a steady rest.
34.  Avoid small chuck diameters with large turning diameters.
35.  Avoid short chucking lengths and small chucking contact.
36.   Turn off the machine and disconnect from power before cleaning. Use a brush to remove shavings or debris — do not

use your hands.

37. Do not stand on the machine. Serious injury could occur if the machine tips over.
38. Never leave the machine running unattended. Turn the power off and do not leave the machine until moving parts

come to a complete stop.

39.  Remove loose items and unnecessary work pieces from the area before starting the machine.
40.  Direction of feed — feed work into a blade or cutter against the direction of rotation of the blade or cutter only.
41.   Installation work and electrical wiring must be done by qualified electrician in accordance with all applicable codes

and standards.

42.  Tighten all locks before operating.
43.  Rotate workpiece by hand before applying power.
44.  Rough out workpiece before installing on faceplate.
45.  Do not mount split workpiece or one containing knot.
46.  Use lowest speed when starting new workpiece.