11
Filter Bag Kit Assembly
If you purchased a DC-1100VX-BK, or DC-1100VX-
5M Dust Collector, this section describes the assembly
and installation of the contents of the Filter Bag Kit
(SN 708636F or 708636MF).
Filter Bag Installation
Referring to Figure 8:
1. Place
the
hanger
(A) on the
hanger bracket
(B).
2. Slide
the
filter bag loop
(C) over the hanger hook.
3. Feed
the
retainer strap
(D) through the loops on
the
filter bag
(E) and fasten to the
collector
housing
(F).
Collector Bag Installation (30 Micron Kit)
Referring to Figure 9:
4. Insert the ring of the
collector bag
(A) at an angle
into the
housing
(B) through the opening at the
bottom. Pull down on the bag to make sure it
“seats” in the housing.
5. Position the plastic window in front so that you can
easily see when the collector bag is full.
Collector Bag Installation (5 Micron Kit)
The 5-Micron Filter Bag Kit includes clear plastic
collector bags. Refer to Figures 11 and 12 on the next
page, along with the accompanying instructions, to
install these.
After completing the filter bag and collector bag
installation, proceed to
Electrical Connections
.
Figure 8
Figure 9
Summary of Contents for DC-1100VX-CK1
Page 16: ...16 Parts Parts Breakdown DC 1100VX Dust Collectors...
Page 22: ...22 Wiring Diagram DC 1100VX Dust Collectors...
Page 23: ...23...
