8
4.
Press the smaller gasket (o-ring type), into
the groove of the lower stand, where the
inlet mounts. Attach the inlet (A, Fig. 4) to
the lower stand inlet hole using six M6x12
pan head screws (B, Fig. 4).
5.
Press the larger gasket (o-ring type) into the
groove of the upper stand. Attach the upper
stand to the lower stand using eight M6x20
cap screws, eight flat washers, eight lock
washers and eight M6 hex nuts (A, Fig. 5).
6.
Attach the handle (A, Fig. 6) to the support
tubing using four M6x50 cap screws, four
M6 flat washers, four M6 lock washers and
four M6 hex nuts (B, Fig. 6).
Summary of Contents for DC-1200FS
Page 12: ...12 Parts Breakdown ...
Page 15: ...15 Wiring Diagram ...
