15
E-1236VS
8.0 ELECTRICAL CONNECTIONS
!
Electrical connections must be made by a
qualified electrician in compliance with all relevant
codes. This machine must be properly grounded
while in use to help protect the operator from
electrical shock and possible fatal injury.
The main motor is rated for 230 volt only. Confirm that
power available at the lathe’s location is the same rating as
the lathe.
IMPORTANT:
The lathe must be wired properly
and phased correctly. The spindle should rotate
counterclockwise (as viewed from the tailstock end) while
the feed rod rotates clockwise (as viewed from the tailstock
end). If the phasing needs correction, disconnect lathe
from power source and switch any two of the three power
leads (not the green ground wire).
If wiring for single phase input, connect at R and T, as
shown in the wiring diagram in section 14.0.
Make sure the lathe is properly grounded.
Fig. 18
Cable receiver
Main switch
9.0 BASIC CONTROLS
Fig. 19
B
C
D
F
I
G
E
H
A
1.
Control Panel
: Located on front of headstock.
•
Power Indicator Light
(A, Figure 19).
Illuminates whenever lathe is receiving power.
•
Coolant On-Off Switch
(B, Figure 19).
Activates coolant pump.
•
Jog Button
(C, Figure 19).
Quickly press and release to rotate spindle.
•
Emergency Stop Button
(D, Figure 19).
Shuts down all machine functions.
Note: Lathe will still have power. Twist button
clockwise to reset.
•
Motor Speed Switch
(E, Figure 19).
Turn to select high or low speed.
2.
Speed Selection Levers
(F, Figure 19): Move levers
left or right to desired spindle speed, according to
accompanying chart.
3.
Feed Direction Knob
(G, Figure 19): Rotating the
knob changes direction of feed. Center position is
neutral.
!
Do not move feed direction knob (G) while
machine is running.
Summary of Contents for Elite E-1236VS
