Jet IBDG-248, Operating Instructions And Parts Manual

4 

25.  When installing a new disc, be certain the disc 

is accurately centered on the drive wheel. 
Failure to do so could cause an unbalanced 
condition. 

26. Always present the workpiece to the wheel 

while resting the workpiece firmly on the table. 
Failure to do so could result in damage to the 
workpiece or throwing of the workpiece off the 
wheel. 

SAVE THESE INSTRUCTIONS

Familiarize yourself with the following safety notices used in this manual: 

 This means that if precautions are not heeded, it may result in minor injury and/or possible 

machine damage. 

 This means that if precautions are not heeded, it may result in serious, or possibly even fatal, 

injury. 

2.0

  About this manual 

This manual is provided by JET, covering the safe operation and maintenance procedures for a JET Model IBDG 
series Belt and Disc Sander. This manual contains instructions on installation, safety precautions, general 
operating procedures, maintenance instructions and parts breakdown. Your machine has been designed and 
constructed to provide consistent, long-term operation if used in accordance with the instructions set forth in this 
document.  

If there are questions or comments, please contact your local supplier or JET. JET can also be reached at our 
web site: www.jettools.com. 

Retain this manual for future reference. If the machine transfers ownership, the manual should accompany it. 

  Read and understand the entire contents of this manual before attempting assembly or 

operation!  Failure to comply may cause serious injury! 

Register your product using the provided mail-in card, or register online:    

http://www.jettools.com/us/en/service-and-support/warranty/registration/ 

WARNING:

 This product can expose you to 

chemicals including lead which is known to the 
State of California to cause cancer and birth 
defects or other reproductive harm. For more 
information go to http://www.p65warnings.ca. 
gov. 

WARNING:

 Some dust, fumes and gases 

created by power sanding, sawing, grinding, 
drilling, welding and other construction activities 
contain chemicals known to the State of 
California to cause cancer and birth defects or 
other reproductive harm. Some examples of 
these chemicals are: 



  lead from lead based paint 



 crystalline silica from bricks, cement and 

other masonry products 



 arsenic and chromium from chemically 

treated lumber 

Your risk of exposure varies, depending on how 
often you do this type of work. To reduce your 
exposure to these chemicals, work in a well-
ventilated area and work with approved safety 
equipment, such as dust masks that are 
specifically designed to filter out microscopic 
particles. For more information go to 
http://www.p65warnings.ca. gov/ and http://www 
.p65warnings.ca.gov/wood.