Mains ..................................................... 1~230V, PE, 50Hz
Motor output power ............................ 0,37 kW (0,5 HP) S1
Reference current ......................................................... 3 A
Extension cord (H07RN-F): ................................. 3x1.5mm²
Installation fuse protection ............................................ 10A
Protection class ................................................................. I
4.2 Noise emission
Acoustic pressure level (EN ISO 11202):
Idling ......................................................... LpA 67,4 dB (A)
In operation ............................................... LpA 75,5 dB (A)
The specified values are emission levels and are not
necessarily to be seen as safe operating levels.
As workplace conditions vary, this information is intended to
allow the user to make a better estimation of the hazards
and risks involved only.
4.3 Content of delivery
10mm drill chuck
Chuck key
Spindle extension
5/8” (15,87mm) chisel bushing
3/4” (19.05mm) chisel bushing
13/16” (20,64mm) chisel bushing
Fence assembly
Work hold down
MDF table
Handle
Gas spring
Operating manual
Spare parts list.
5. Transport and start up
5.1 Transport and installation
The machine is designed to operate in closed rooms and
must be bolted stable on a firm and levelled table surface.
5.2 Assembly
If you notice transport damage while unpacking, notify your
supplier immediately. Do not operate the machine!
Dispose of the packing in an environmentally friendly
manner.
Clean all rust protected surfaces with a mild solvent.
Screw the handle (A, Fig 1) into the pinion shaft (B, Fig 1)
and tighten (C, Fig 1).
Fig 1
Use the handle to raise the machine head to the up position.
The handle is spring loaded and can be repositioned by
pulling the handle away from the head, and turned to the
desired angle.
Press the gas spring onto the two fittings (D and E).
Attach the MDF table to the base using two screws (A, Fig
2).
Fig 2
Insert bar of fence assembly (B) through the hole in the
column. Use the indexable knob (C) to adjust the fence
assembly.
Attach the hold down (D) to the vertical post using locking
handle (E).
