6
Read and understand the
entire contents of this manual before attempting
assembly or operation. Failure to comply may
cause serious injury.
5.0
Setup and assembly
5.1
Unpacking and cleanup
Remove all contents from shipping carton, and
remove accessories from drawer inside stand. Also,
the adaptor is shipped inside the cabinet behind the
filter door. Remove door to access.
Compare parts to the contents list in this manual. If
shipping damage or any part shortages are
identified, contact your distributor. Do not discard
carton or packing material until dust collector is
assembled and running satisfactorily.
5.2
Shipping contents
1
Dust Collector
1
Operating Instructions & Parts Manual
1
Product Registration Card
Package 1:
1
Inlet port 3-in. dia.
3
Flange Head Screws, 3/16 x 1/4 in.
Package 2:
4
Hex nuts, 1/4 in.
4
Foot pads, 1/4 x 3/4 in.
5.3
Tools required for assembly
Cross
point (“Phillips”) screwdriver
4 mm hex key (Allen wrench)
5.4
Assembly
1. Release drawer by turning knob counter-
clockwise (see Figure 5-1) and remove the
packages from the drawer. Close drawer and
rotate knob clockwise to secure.
2. Screw hex nuts onto threads of foot pads, and
install pads beneath the corners of the unit.
Each pad can be turned slightly in or out to help
level the unit. Tighten each hex nut against the
bottom of the unit.
3. Attach a 3-in. diameter dust hose (not provided)
to the inlet port. A hole in the inlet allows
insertion of a screw to secure the hose to the
inlet. Or a hose clamp can be used.
Figure 5-1
6.0
Operation
Do not mix ferrous and non-
ferrous metal dust in the same dust collector.
Failure to comply will result in increased risk of
fire.
6.1
On/off switch
Push up switch to start the unit, push down to stop.
The switch has a yellow safety key to prevent
unauthorized use. Pull out key to deactivate switch.
Key must be reinserted to start machine
– press until
it snaps back in.
6.2
Overload reset
If the machine overloads, it will shut off. Wait a few
moments for machine to cool, then press the reset
button (next to the On/Off switch) to restart.
