18
Outfeed table too high
– If the outfeed table is
too high, a curved finished surface results
(Figure 8-16).
Figure 8-16
Outfeed table too low
– If the outfeed table is too
low, the work will have a gouge, or snipe, at the
end of the cut (Figure 8-17).
Figure 8-17
Outfeed table at correct setting
– Figure 8-18
illustrates the correct setting of outfeed table
level with the knives. The workpiece will rest
firmly on both tables with no open space under
the finished cut.
Figure 8-18
9.0
Operating controls
1. Handwheel for Outfeed Table
2. Outfeed Table
3. Fence
4. Fence Adjustment Handle
5. Cutter Guard
6. Infeed Table
7. Handwheel for Infeed Table
8. On/Off Switch
9. Table Lock Knob
10. Fence Tilt Lock Handle
11. Belt Guard
12. Fence Travel Lock Handle
13. Depth Limiter
Summary of Contents for JJ-6HHDX
