11
Jointer-Planer Assembly
Referring to Figure 7:
Fence
1. Attach
jointer
fence
(A) to back of jointer
outfeed
table
(F
3
) with two each
socket head cap screws
(Z) and
lock washers
(MM). Tighten screws with
5mm hex wrench (provided).
Lock Knobs
The JJP-10BT Jointer-Planer comes equipped with
two lock knobs to secure the position of the jointer
infeed table.
2. Install jointer infeed table
lock knobs
(V, R).
Note:
The shaft length of each lock knob (refer
to Figure 3) are different. Be sure to install each
in the correct location.
Extension Table
3. Attach the planer outfeed
extension table
(J) to
the
main
planer table
(F
4
) with three each
socket head cap screws
(AA) and
flat washers
(HH). Tighten screws with 5mm hex wrench.
Extension Table Adjustment
Two setscrews located underneath the
extension
table
(J) are used to adjust the height position of the
outer (protruding) edge, which must be slightly
higher than the
main planer table
(F
4
) in order to
minimize snipe (see
Avoiding Snipe
on page 21).
4. Using a 4mm hex wrench (provided), turn
setscrews slightly clockwise to raise the table or
counterclockwise to lower the table.
Lock Handle
Referring to Figure 8:
Attach planer table
lock handle
(U) and
flat washer
(T).
Cutterhead Guard
5. Install
cutterhead guard
(C) by securing the
bracket
(C
1
) to the side of the
jointer infeed
table
(F
5
) with two each
pan head machine
screws
(FF) and
hex nuts
(GG).
Important:
It is extremely important that spring
action causes the
cutterguard
(C) to retract against
the
fence
(A), concealing the
cutterhead
(A
1
). If
spring return tension is not enough, adjust the spring
located on the cutterhead pivot shaft accordingly.
Figure 7
Figure 8
Summary of Contents for JJP-10BTOS
