12
Jointer Setup
Disconnect machine from power
source before making any adjustments. Failure
to comply may cause serious injury.
Referring to Figure 9:
1. Loosen
lock handle
(U).
2. Install planer table
height adjustment handle
(S).
3. Turn
handle
(S) counterclockwise and lower
planer
table
(F
1
) all the way.
4. Remove
hex nut
(B
1
) and
flat washer
(B
2
) from
dust chute
(B).
5. Orient
the
dust chute
(B) as shown and install
into the infeed opening.
Position the
chute
(B) such that the two
positioning keys and one threaded positioning
screw underneath the chute meshes with three
positioning holes on the
table
(F
1
).
6. Raise the table (turn handle S clockwise) until
the
dust chute
(B) is held firmly in place
between the
planer infeed table
(F
1
) and
jointer
outfeet table
(F
2
). Do not overtighten.
7. Tighten
lock handle
(U).
Step 8 is optional.
8. Further secure the dust chute by reinstalling the
hex nut
(B
1
) and
flat washer
(B
2
) from
underneath the
planer infeed table
(F
1
).
9. Remove
handle
(S).
Planer Setup
If the machine is currently set up for jointer
operation, remove the
dust chute
(B, Fig. 9). Refer
to the
Jointer Setup
section above.
Referring to Figure 10:
1. Swing
cutterguard
(C) away from
fence
(A),
which will expose the cutterhead.
Cutterhead knives are
dangerously sharp. Use extreme caution when
working around them. Failure to comply may
cause serious injury.
2. Orient
the
dust chute
(B) as shown. Install onto
the
jointer outfeed table
(F
2
) and secure by
tightening
lock knobs
(B
4
).
Figure 9
Important:
Dust chute
(B) must be properly installed in
both Jointer setup and Planer setup. If improper
installation fails to activate a micro-switch, the machine
will not start.
Figure 10
Summary of Contents for JJP-10BTOS
