14
Jointer Controls and Adjustments
Refer to Figure 13.
Infeed Table Height Adjustment
Two
lock knobs
(F) and a
height adjustment knob
(E) control the height adjustment of the
infeed table
(D).
To adjust:
1. Loosen
lock knobs
(F).
2. Turn
the
height adjustment knob
(E) clockwise
to raise the
infeed table
(D) or counter-clockwise
to lower the table.
The amount of table adjustment can be read on
the
scale
(C).
3. Tighten
the
lock knobs
(F).
Note:
A depth of cut of 1/16" or less is recom-
mended.
Cutterhead Guard
Properly positioned, the
cutterhead guard
(A) should
rest against the
fence
(B
1
).
Fence Bevel Adjustment
The
fence
(B
2
) can be tilted
backward
(G) up to 45°
(that is, for a total included angle of 135° from table
surface) as follows:
1. Loosen
lock handle
(J).
2. Tilt
the
fence
(B
2
) back to the desired angle up
to 135 degrees (G). Or you can place your
beveled reference piece on the table and
against the fence, adjusting the fence until the
angle of the fence matches the bevel of your
gauge piece.
3. Tighten
the
lock handle
(J).
Figure 13
Summary of Contents for JJP-10BTOS
