10
•
When lifting loads, hook the load with slings.
Do not use the lever hoist chain as a sling,
(Figure 11).
Figure 11
•
Both ends of a sling or rope must be
completely on the inside of the safety latch
before pulling or lifting the load. Do not put
one end on the inside of the latch and leave
the other end on the hook end outside the
latch.
11.0
Point hooks
Point or “shipyard” hooks are available for your JET
lever hoist, in 1-1/2 ton and 3 ton load sizes. They
are available in both upper and lower hook styles.
Point hooks are used in the metal and ship building
industries, and are designed for positioning steel
plate and fixtures before welding.
12.0
Inspection and
maintenance
Read and follow ANSI Inspection and Maintenance
Instructions. Know the meaning of Frequent
Inspection, Periodic Inspection, Normal Service,
Heavy Service, and Severe Service. It is the
customer’s responsibility to understand and follow
all ANSI and JET inspection and maintenance
instructions.
The lever hoist should be stored in a clean, dry
environment. Clean and oil the hoist before
storage.
Hoists that are installed out-of-doors should be
covered or brought inside when not in use.
Periodically apply a light coat of 30 weight oil to the
load chain. Also lubricate the safety latches and the
bearings in the hooks.
Annually, the hoist should be disassembled,
inspected, and cleaned by trained and experienced
personnel only. Contact a JET authorized service
center by calling your dealer or visiting our web site
at jettools.com.
