Jet JPM-13CS, Operating Instructions And Parts Manual

8

7.0

  Specifications  

Model number ........................................................................................................................................ JPM-13CS 
Stock Number ............................................................................................................................................. 708524 
 
Capacities: 
 Maximum 

Cutting 

Width 

................................................................................................................. 13” (330 mm) 

 Maximum 

Thickness 

.................................................................................................................. 6-1/8” (156 mm) 

  Full Width Depth of Cut ................................................................................................................................ 1/16” 
  Minimum Planing Length ............................................................................................................... 14” (356 mm) 
  Cuts per Minute ........................................................................................................................................ 13,500 
  Feed Rate, Planing ................................................................................................................................... 20  fpm 
 Feed 

Rate, 

Molding 

.................................................................................................................................. 10  fpm 

 
Cutterhead: 
  Number of Knives .............................................................................................................................................. 3 
 Knife 

Size 

.................................................................................................................... 13-1/16”L x 1/8”W x 5/8”H 

 Cutterhead 

Diameter 

................................................................................................................................ 2-9/16” 

  Cutterhead Speed (RPM) ............................................................................................................................ 4500 
 
Motor and controls: 
  Motor type ................................................................ totally enclosed fan cooled, induction, capacitor start 
 Horsepower 

.................................................................................................................................... 1-1/2  HP 

 Phase 

.................................................................................................................................................. single 

  Voltage ............................................................................................................... 115/230V (prewired 115V) 
 Cycle 

.................................................................................................................................................... 60Hz 

  Listed FLA (full load amps) ............................................................................................................. 15/7.5  A 
 RPM 

..................................................................................................................................................... 3450 

 Start 

capacitor 

................................................................................................................. 400MFD,  125VAC 

 Power 

transfer 

..................................................................................................................................... v-belt 

 On/off 

switch 

............................................................................................................................. push button 

 Motor 

speed 

................................................................................................................................ 3450  RPM 

  Power plug installed ............................................................................................................................. 120V 
  Recommended circuit and fuse/breaker size

1

 .................................................. 30A (115V), or 15A (230V) 

                                     1

 subject to local/national electrical codes.        

 
Dust collection: 
  Dust port outside diameter ........................................................................................................ 4” (100mm) 
  Minimum extraction volume required ............................................................................ 350 CFM (18CMM) 
 
Dimensions and weights: 
  Overall  Dimensions ........................................................................................ 23-31/32”W  x  36-1/2”D x 43-1/2”H 
 Net 

Weight 

(approx.) 

.................................................................................................................... 225 lb (102 kg) 

 Shipping 

Weight 

(approx.) 

........................................................................................................... 262 lb (119 kg) 

The specifications in this manual were current at time of publication, but because of our policy of continuous 
improvement, JET reserves the right to change specifications at any time and without prior notice, without incurring 
obligations.

IMPORTANT: 

∗

The use of a dust chute and adequate dust collection system is highly recommended but not 
required for most planing operations. 

∗

The use of a dust chute and adequate dust collection system is required for all molding operations.

For a complete line of woodworking dust collectors, contact your local JET distributor, or visit our website at 
www.jettools.com.