GB ‐ ENGLISH
Operating Instructions
Dear Customer,
Many thanks for the confidence you have shown in us with the purchase of your new JET‐machine. This manual has been prepared
for the owner and operators of a
JET JSS‐16A
scroll saw to promote safety during installation, operation and maintenance
procedures. Please read and understand the information contained in these operating instructions and the accompanying documents.
To obtain maximum life and efficiency from your machine, and to use the machine safely, read this manual thoroughly and follow
instructions carefully.
…Table of Contents
1. Declaration of conformity
2. Warranty
3. Safety
Authorized use
General safety notes
Remaining hazards
4. Machine specifications
Technical data
Noise emission
Contents of delivery
Machine description
5. Transport and start up
Transport and installation
Assembly
Dust connection
Mains connection
Starting operation
6. Machine operation
7. Setup and adjustments
Changing the saw blade
Saw blades with pin
Saw blades without pin
8. Blade selection
9. Maintenance and inspection
10. Troubleshooting
11. Environmental protection
12. Available accessories
1. Declaration of conformity
On our own responsibility we hereby declare that this product
complies with the regulations listed on page 2.
Designed in consideration of the standards.
2. Warranty
The JPW (Tool) AG guarantees that the supplied product is free
from material defects and manufacturing faults.
This warranty does not cover any defects which are caused,
either directly or indirectly, by incorrect use, carelessness,
accidental damage, repair, inadequate maintenance or
cleaning and normal wear and tear.
Any warranty details (i.e. warranty period) can be found in the
General Terms and Conditions (GTC) that are
integral part of the contract. These GTC can be viewed at the
website of your dealer or sent to you upon request.
JPW (Tool) AG reserves the right to make changes to the
product and accessories at any time.
3. Safety
3.1 Authorized use
This machine is designed for sawing wood, wood derived
materials as well as similar to be machined hard plastics only.
Machining of other materials is not permitted and may be
carried out in specific cases only after consulting with the
manufacturer.
The workpiece must allow to safely be loaded, supported and
guided.
The proper use also includes compliance with the operating
and maintenance instructions given in this manual.
The machine must be operated only by persons familiar with
its operation, maintenance and repair and who are familiar
with its hazards.
The required minimum age must be observed
The machine must only be used in a technically perfect
condition
When working on the machine, all safety mechanisms and
covers must be mounted.
In addition to the safety requirements contained in this
operating instructions and your country’s applicable
regulations, you should observe the generally recognized
technical rules concerning the operation of woodworking
machines.
Any other use exceeds authorization.
In the event of unauthorized use of the machine, the
manufacturer renounces all liability and the responsibility is
transferred exclusively to the operator.
3.2 General safety notes
Woodworking machines can be dangerous if not used properly.
Therefore the appropriate general technical rules as well as
the following notes must be observed.
Read and understand the entire instruction manual before
attempting assembly or operation.
