Bevel cutting:
The table can be tilted between 0° and 45° for bevel cutting.
Loosen the locking knob (H).
Fig 5
Tilt the table to the left until the desired angle on the scale (G)
has been reached.
Retighten the locking knob.
Fig 6
Attention:
Angle cutting requires more care.
Be careful.
7. Setup and adjustments
General note:
Setup and adjustment work may only be carried out after the
machine is protected against accidental starting by pulling
the mains plug.
7.1 Changing the saw blade
The machine accepts pin blades and plain end blades.
Check sawblade for flaws (cracks, broken teeth, bending)
before installation. Do not use faulty sawblades.
The sawblade teeth must point in cutting direction (down)
The sawblades may only be changed when the mains plug is
pulled!
Open the transparent sawguard.
Remove the table insert (M)
Release blade tension.
Fig 7
The quick release blade tension knob (A) allows a quick and
easy blade change.
Replace the sawblade.
The teeth of the blade must point in the cutting direction
(down).
The sawblade tension can be adjusted by turning the tension
knob.
Fig 8
Turn clockwise to increase tension (Fig 8).
Reposition the table insert and the transparent sawguard.
7.2 Saw blades with pin
The machine accepts pin blades.
The upper and lower blade holders are equipped with slots and
pin recesses (Fig 9).
Fig 9
You can position the blade for cutting from the front or from
the side.
