9
Hand Wheel Assembly
•
Hardware: (2) Handles, (2) Hand Wheels & (2)
Lock Knobs
•
Tool: 14mm Wrench
1.
Attach handle (A, Fig. 4) to hand wheel (B,
Fig. 4).
2.
Attach hand wheel assembly to saw with
lock knob (C, Fig. 4).
3.
Make sure the pin (D, Fig,4) aligns with the
notch in the hand wheel. Repeat for second
hand wheel.
Blade Guard Assembly
•
Hardware: (1) Blade Guard Assembly, (1)
Blade Guard Post (1) M16 Nut & Lock Washer &
(3) M10 Flat Washers
•
Tools: 13mm Wrench, 3mm Hex Wrench and a
Cross Point Screwdriver
1.
Thread a M16 hex nut and M16 Lock
Washer (A, Fig. 5) completely onto the
blade guard post (B, Fig. 5).
2.
Thread blade guard post into trunnion at the
rear of the saw, (Figure 5). Tighten by
placing a cross point screw driver through
the hole at the end of the post and turning
clockwise.
3.
Slide lower blade guard bracket (A, Fig. 6)
onto blade guard post and tighten set
screws (B, Fig. 6) just enough to hold the
bracket in place.
4.
Attach upper blade guard bracket (C, Fig. 6)
to lower blade guard bracket with two hex
cap bolts, four flat washers, two lock
washers and two hex nuts (D, Fig. 6). Hand
tighten only at this time.
Summary of Contents for JWCS-10A
Page 15: ...15 Cabinet Table Assembly...
Page 18: ...18 Motor Trunnion Assembly...
Page 21: ...21...