7
3
Use of a carrier or backer board (not provided) is recommended for cuts 1,5 mm or less. See section 9.4.
L=length, W=width, H=height, Dia=diameter
The specifications in this manual were current at time of publication, but because of our policy of continuous
improvement, JET reserves the right to change specifications at any time and without prior notice, without incurring
obligations.
5.0
Features and Terminology
The illustration below shows the major components and features of the JWDS‐1020‐M Sanders. These are referenced
throughout the manual and will help to familiarize you with the operation and functions of the machine.
Figure 5‐1: features and terminology
Read and understand the
entire contents of this manual before
attempting set‐up or operation. Failure to
comply may cause serious injury.
6.0
Setup and assembly
Open box and check for shipping damage. Report any
damage immediately to your distributor and shipping
agent. Any missing parts should be reported to your
distributor. Do not discard shipping material until the
Drum Sander is assembled and running satisfactorily.
6.1
Shipping contents
1
Sander with conveyor table
1
Handle
4
Foam pads
1
Operating manual
1
Spare parts list
6.2
Tools required for assembly
3mm hex wrench
Straight edge (such as straight steel bar or carefully
jointed board)
Additional tools may be needed for adjustments or
mounting the sander to a workbench.
