5
5.0
Assembly (for crate quantity purchases only)
5.1
PTJ-B series (except PT-1636JB) Assembly
Individual pallet trucks are assembled and ready to use. Pallet trucks purchased in crate quantities (6 units to a
crate) require some assembly. A hammer and pliers are required.
Match the “letter” label on the handle
assembly to the “letter” label on the frame, prior to assembly.
Note: The following illustrations may not show your exact model.
To attach handle assembly to the frame:
1. Align the holes in the handle with the holes in
the pump body. Tap the pivot pin through the
handle and pump bodies.
2. Using pliers, turn the pivot pin until spring pin
holes line up.
3. Using a hammer, tap the spring pin into the
pump body and pivot pin.
4. Lower the handle until the spring cap is
contacted. (This will reduce some of the
pressure on the pump retainer pin, making it
easier to remove.)
5. Tap out the pump retainer pin and discard it.
6. Feed the chain anchor through the hole in the
pivot pin.
7. Position the chain anchor through the fork of
the relief cam, with the lock nut below the fork.
