6
Assembly
Note:
Individual pallet trucks are assembled and ready to use. Pallet trucks purchased in crate quantities (6
units to a crate) require some assembly. Match the “letter” label on the handle assembly to the “letter” label on
the frame, prior to assembly.
Tools required for assembly:
Hammer
Pliers
To attach handle assembly to the frame
(Figures 2-6)
:
1. Remove the spring pin.
2. Tap out the pivot pin.
3. Align the holes in the handle with
the holes in the pump body. Tap
the pivot pin into the handle and
pump body.
4. Using pliers, turn the pivot pin until
spring pin holes line up.
5. Using a hammer, tap the spring pin
into the pump body and pivot pin.
6. Lower the handle until the spring cap is
contacted. (This will reduce some of the
pressure on the pump retainer pin, making
it easier to remove.)
7. Tap out the pump retainer pin and discard
it.
8. Feed the chain anchor through the hole in the
pivot pin.
9. Position the chain anchor through the fork of the
relief cam, with the lock nut below the fork.
