4.4 Attach Eyebolt or Eyescrew to the mounting structure. The guy cable should
be at 30 - 45° from the centre axis of the fan (see below illustration). Place the
Eyebolt / screw accordingly.
4.5 Attaching Guy Cable Loop 2: Insert wire thimble into the 5/16” eye bolt and
route the second end of the guy cable through the wire rope clips and wire
thimble to make second Loop. Refer to Step 4.1 for detailed instructions of Guy
Wire Loop. Loosely tighten the guy cable by pulling the dead end of the guy
cable.
(Do not use Beam-Clamp as shown in image, use eyebolt as per instruction)
NOTES:
Do not tighten guy cable until all the remaining guy cables have been installed.
After routing, cut off any excess cable on dead end.
4.6 Repeat Steps 4.1 to 4.4 to install the remaining 3 Guy Cables.
4.7 Evenly tighten guy cables by turning all the Turnbuckles. The guy cables
should be taut.