INF
O@jetboards.mx
jetboards.mx
-
USER AND SAFETY MANUAL - kymera
know before you go
It is the operator’s sole responsibility to know and follow any and all rules / regulations related to
operation in any given water way.
Each state / country and sometimes even county or specific water way can have their own
regulaion so its critical to contact the proper authorities prior to operation.
If you should need help with classification or clarification on specifics of
KYMERA
to gain approval
for your local waterway please contact your local representative we will be happy to help.
new board break in
Do not operate your board out of the water. This is particularly important prior to break in.
During the first hours of operation its critical to allow all components to properly wear in. This is
accomplished by simply taking care to run the board through its full RPM range repeatedly to full
power, avoiding prolonged (more than a few minutes at a time) full power operation for the first
2~3 charge cycles. Peak efficiency is typically achieved after 5~6 cycles.
LAunching kymera
Whenever possible use stands or other means to prevent the board from resting directly on the
ground. This will reduce the chance of debris entering the pump and or hull.
turning your board on
- Adult supervision is required
Once the plug is fully seated, verify the throttle trigger is in the full forward position
(OFF position).
Next, switch the battery to the ON position.
After switching the main power to ON, the board will then verify throttle position and arm. This
will take 5~10 seconds and you will hear 3 to 4 beeps. Once the beeps stop, the board is armed
and ready to use. Make sure that during the arming process the throttle is not moved or
activated.
7