computer radio control system
EN
Switch Exchange:
1.
Switch off the transmitter and remove the 10 screws that secure
the radio back cover. Next, remove the radio back cover.
Be sure
to disconnect the transmitter battery pack connector.
2.
With the specialized wrench (not included) carefully loosen and
remove the switch installation nut.
3.
Carefully hold the switch by its printed circuit board assembly
and slowly pull it out. Use this method to also remove and
exchange all of the other switches. After re-assembling and
turning on your transmitter the software will sound a warning
reminding you that you have executed a change. Always
reinspect all assigned functions of the switches before
attempting to fly.
3.5 Digital Trims
Transmitter gimbals are used for controlling the basic flight
functions like throttle, roll(aileron), pitch(elevator), and yaw(rudder).
Immediately under the transmitter gimbal sticks you can see four
push-buttons which are the programmable, digital trim buttons.
The digital trims are used for fine trimming of the flying model. When
the transmitter is turned off, the trim values are stored in memory
and are recalled when the system is turned back on.
Every model has its own trim setup. Also all flight modes may be
configured to use different trim configurations. By pressing one of
the buttons, the screen will automatically change to display the
graphic position of that trim. The transmitter trims feature an
acoustic step and centre beep alarm.
In the "Digital trim“ menu it‘s possible to enable a special
function used as automatic trimming.
Digital trim steps and trim
range setting is explained in
"Main menu->Fine tuning/flight
modes->Digital trim“
20
3
2
Summary of Contents for DC-14 II
