Overview of Receiver Data Items
Once in the Jetibox emulator the Tx screen is displayed, press the
right arrow button to go to the Rx info screen. Then press the down
arrow button to go the Rx introductory screen. The introductory screen
displays the type of receiver. By pushing the right arrow button, more
detailed receiver and transmitter data of can be displayed.
Add Profi info
Direct connection to a Jetibox will display the introductory screen.
Pairing (binding): pressing the up arrow button starts the pairing
(binding) of the receiver with the transmitter. This is simply a legacy
JETIBOX function. This option is not valid for wireless communication.
Pairing of the receiver with this method can only be performed when a
JETIBOX is directly connected to the receiver.
RX/TX: The Item RX item shows the unit production number of the
receiver. The TX item shows the unit production number of the
transmitter, to which the receiver has been paired.
Rx Firmware: This screen shows the firmware version of the bound
receiver.
Rx Diag: Item A1 or A2 shows which antenna the receiver is using at
the moment. Item Kx displays the number of transmitted channels
(this number depends on the transmitter’s capabilities).
By pressing the arrow down button you arrive at the D line of basic
mode selections, here is where you may select to display the
measured values (Measure) or the setup of the receiver (Main setting,
Channel set, Out Pin Set, Auto Set).
Measure: selects the display for the measured data showing the
maximum, minimum and actual receiver voltages.
-U Min / UAct / UMax : the receiver monitors its supply voltage and
indicates limit values and extremes which occurred during operation;
at the same time it also shows the actual receiver voltage. For
receivers directly connected to a Jetibox: Without switching on the
paired transmitter, the values MAX and MIN will not change; only the
value of the actual voltage “Uact” will be updated. To delete the MAX
and MIN values, press the left arrow button and the right arrow button
simultaneously.
Main setting: Basic setup, here you may adjust the general
properties of your receiver which are common to all output channels.
