- Signal Fault Delay: specifies the deadline after which the receiver
outputs change due to signal loss to
preadjusted positions of the particular outputs or after which they
become switched off (due to setup of Signal Fault
in the menu Out Pin Set).
- Volt act/alarm: the first item shows the actual receiver supply
voltage, the second value serves for the setup of
the alert decision threshold. As soon as during operation the actual
voltage decreases below the set threshold, the
transmitter will announce this situation by an acoustic tone.
- Output Period: setup of the output signal period (standard setup
20ms), analog servos respond faster with lower
values (shorter response time) and consume more current. If the
value is set too low some servos may chatter. The
output period may also be synchronized with the transmitter - Output
Period - By Transmitter.
-RX mode: this setup switches the receiver to monitoring mode
(Clone). This mode should only be used in
applications with two or more receivers, working simultaneously in a
model in connection with a single transmitter
module. One receiver should work as master receiver (Normal) and
the others in monitoring mode (Clone). The mode
change (Normal / Clone) must be carried out only with the JETIBOX
connected directly to the receiver.Telemetric
sensors can be operated with a receiver in Normal mode only.
-PPM Output mode (applicable to RSat receivers only) Setup of the
satellite receiver mode
-Computed: the signals received from the transmitter can be
processed furtheron in the receiver and
its menus Channel setand Out Pin Set(mixers, programmable channel
outputs a.s.o.)
-Direct: signals received from the transmitter are notfurtheron
processed in the receiver, they are
generated without any change at the output of the sallite receiver in
form of PPM signals
-Number of PPM Output Pulses: (valid for RSat and RMK) Setup of PPM
pulse number at the Rsat receiver. If there
are transmitted less channels than the set number of PPM pulses at
the receiver, then the remaining pulses will be
replaced by one pulse with a length corresponding to the pulse length
adjusted in the FailSafe menu of the given
channel. In the reverse case the number of output pulses will be
reduced to the default setting number.
Receivers EN
